Description

This Alembic F-1X tube mic preamplifier with three-band equalizer is Used and in Very Good Condition; some light scratches on the exterior from rackmounting. Fully tested and working perfectly. The Alembic F-1X is the mono version of the classic F-2B preamp (which was Alembic's first official product, introduced in 1969). It has a signature, warm fat tube tone but with extended low frequency response and hi-fi clarity. The F1X shares the same tone section of the original F2B but has added features like a direct output, built-in effects loop and crossover (the F-1X also includes a standard full range output for simpler setups). Favored by guitar and bass players alike, Alembic preamps have been used by notable players like David Gilmour, Jerry Garcia, Stanley Clarke, Bootsy Collins, Phil Lesh and many more. Two input jacks provide the same functionality as found on the F-2B preamplifier. The input is buffered by a cathode follower tube circuit, which is a unity-gain impedance matching amplifier to feed the guitar level effects loop. This gives minimum loading on the output signal from the guitar while driving the effects loop gear with the same signal voltage level as the guitar but at a lower impedance, to isolate cable and other loading effects from the guitar pickups. The other half of the 12AX7 tube provides the preamp's gain. This gain comes before the volume control and the 300 volt supply assures that even large transients are handled without overload or distortion. The tone controls are the interacting Fender circuit. The bright switch shunts high frequencies around the volume control. The deep switch changes a capacitor value in the bass control to change the frequency response (and a second section on the deep switch changes the gain of the following amplifier to compensate for the resulting change in signal level). A solid state circuit restores the signal level after the volume control and provides impedance matching to drive the full range output jack on the rear panel. Additionally, it drives the crossover network. The active crossover network provides 12 dB/Oct slopes to divide the output for bi-amping. The crossover points occurr at 6 dB down so that the acoustic signals from the loudspeakers add seamlessly. A front panel control trims the high-frequency signal component to match the level of the low frequency output. A transformer-isolated balanced output to an XLR type connector provides auxiliary Recording or PA feed. A switch selects the source to be the effects return (Pre) or the full range output (Post). The transformer is large enough to handle the low-frequencies without distortion to give good clear lows and a resistive pad isolates the transformer from loading effects of long cables to give clear highs. The heater of the 12AX7 tube is supplied by a regulated direct current supply to assure low hum. The AC Line (Mains) connection is an IEC (computer-type) detachable cord. The supply voltage can be changed by moving jumpers inside the unit to operate from 100, 120, 220, and 240 volts for operation anywhere in the world. The F-1X is housed in a sturdy, road worthy, steel enclosure. FREE SHIPPING WITH TRACKING AND INSURANCE FOR US BUYERS. International shipping through the eBay Global Shipping Program.